home *** CD-ROM | disk | FTP | other *** search
/ Tech Arsenal 1 / Tech Arsenal (Arsenal Computer).ISO / tek-20 / radiomd3.zip / TM721A.11 < prev    next >
Text File  |  1991-03-10  |  2KB  |  44 lines

  1. TM721A.11
  2.  
  3. From: flloyd%crank@Sun.COM (Fred Lloyd)
  4. Newsgroups: rec.ham-radio
  5. Subject: Re: Kenwood TM-621,721 mods ?
  6. Date: 25 Apr 89 21:43:28 GMT
  7. Reply-To: flloyd@sun.UUCP (Fred Lloyd)
  8.  
  9. The programming resistors do the following:
  10.  
  11. 1. Select the European frequency bands (430 - 440)
  12. 2. Select MARS/CAP xmit freqs (141 - 150)
  13. 3. Select unrestricted out-of-band xmit (add a jumper)
  14. 4. Select cross-band repeater mod
  15. 5. Disable built-in 3 minute timeout timer for crossband repeater.
  16.  
  17. Number 1 was easy, I just installed a jumper where there were a pair
  18. of empty pads next to a row of four or five other 0 ohm (jumper) "resistors".
  19. I found this quite useless and promptly removed it.
  20.  
  21. Number 2 is also very easy, but unnessary for 90% of us.  If you need MARS/CAP
  22. then you'll be able to get the details from Kenwood.
  23.  
  24. Number 3 is somewhat of a mystery as I've been told the jumper position
  25. but have been unable to find it on the board.  My interest was in
  26. opening up the UHF receive to hear the public service channels.
  27. Unfortuneatly, this mod opens up transmit as well, on both bands and
  28. apparently without restriction (as the gossip goes).
  29.  
  30. Number 4 is real easy and involves removing the resistor marked R121 on the
  31. schematic.
  32.  
  33. Number 5 is also easy and just remove R122 to do it.  (I haven't though)
  34.  
  35. What I'd like to know concerns the remote control capabilities that are
  36. available through the microphone plug.  From looking at the manual,
  37. it's clear that when the RC-10 remote control handset is used, many of
  38. the radio's front panel controls are made remotely available.  Does
  39. anybody know the manner in which the three data pins on the mike plug
  40. are used for this.  The three pins are PTT, UP and DOWN (in normal
  41. mode).  Presumably, there is a way to communicate with the onboard
  42. microprocessor using these pins.  If so, then somebody could
  43. concievably use their PC to control the radio.
  44.